Monark 828E Instruction Manual download pdf (Page 18)

Fig. 11

Tension lever

Lock washer

Clip

REPLACEMENT OF BRAKE BELT

Remove the tension lever.

Dismantle the front cover over the pendelum weigh by

detatching the 4 screws underneath.

Remove the left or the right frame cover by undoing the

mounting screws (5pcs). Put the crank in a backward posi-

tion. Move the cover somewhat out in the front end and then

take it backwards to remove it.

Loosen the brake belt from the pendelum at the screw and

lock washer. Take it apart at the spring and clip and remove

it from the bike. See fig 11.

Attach the new brake belt and assamble the bike in reverse

order.

NOTE: When replaceing the brake belt it is

recommended to clean the brake surface. See Brake Belt

Contact Surface.

ADJUSTMENT BRAKE BELT

Loosen the tension device to min. load. Adjust the brake belt

so that resistance increases as soon as a the tension device is

turned a little. See fig. 10.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

No comments

Monark 828E Instruction Manual Page 18