Monark 828E Instruction Manual download pdf (Page 19)

Fig.12

Brake surface

Sand paper

BRAKE BELT CONTACT SURFACE - BRAKE BELT

The brake belt should be regularly checked to ensure that it has not suffered

execessive wear. If it looks worn it should be replaced.

Deposits of dirt on the brake belt and on the contact surface may cause the

unit to operate unevenly and will also wear down the brake belt. The brake

belt contact of the flywheel surface should then be ground off with a fine

sand paper and any dust removed with a clean dry cloth.

Dismantle cover see REPLACEMENT BRAKE

BELT.

Set the tension device to min load.

Loosen the brake belt somewhat at the adjustment bolt

and take off the brake belt to the side. Grind with a fine

sand paper. See fig. 12.

Grinding is easier to perform if a second individual

cautiously and carefull pedals the cycle.

Irregularities on the brake belt contact surface are

removed by means of a fine sand paper or an abrasive

cloth. Otherwise unnecessary wear on the brake belt

may occur and the unit can become noisy.

Always keep the brake belt contact surface clean and dry.

No lubricant is allowed to be used.

We recommend to replace the brake belt when cleaning the contact surface.

As regards assembly and adjustment of the brake belt, see previous page.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

No comments

Monark 828E Instruction Manual Page 19