Monark LT2 Troubleshooting Guide download pdf (Page 9)

”LOGO”

LT2

Fig: Placement of the chest belt

Fig: Electrodes on the back of the chest belt (1)

The user's heart rate can be measured with a chest

belt that senses the electronic output of the heart.

Chest belt ANT+ is available as an accessory.

Fuss-free HR measurement requires that the belt is

correctly placed. Make sure that your skin is clean

where the chest belt should be placed. When it is

correctly ﬁtted the logo on the belt will be central and

readable, outward and upright, by another person.

The chest belt should be secured at a comfortable

tension around the mid section, just below the breast

muscle, see Fig: Placement of the chest belt. Moisten

the electrodes before use, see Fig: Electrodes on the

back of the chest belt.

NOTE! Electromagnetic waves can interfere with the

telemetry system. Cellular phones are not allowed to

be used near the bike during test.

Pulse standard (chest belts)

The following pulse standard / chest belts can be

used:

Standard, uncoded 5K chest belts (5-5.6 kHz)•

Chest belts with ANT+•

Short range ANT+: 0.6-0.8 m (24"-31 ½")

Long range ANT+: 4-5 m (13-16 ft)

Range 5K: 0.8 m (31 ½")

Pairing display and chest belt

Normally the display connects to the ﬁrst ANT+ chest

belt in "short range" and shows the heart rate until

the chest belt is outside the "long range". If there is no

ANT+ chest belt but a 5K chest belt in "short range",

the heart rate from the 5K chest belt is displayed until

the signal is lost.

ANT+ is prioritized and the ﬁrst choice of the display.

5K is discriminated, but after 30 seconds with only

5K the display is locked to this chest belt as long as

you do not lose the signal.

Pulse function

Monark Exercise AB recommend that you

use an ANT+ chest belt for best function.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

Monark LT2 Troubleshooting Guide Page 9